July — 2006 — The Expansion Joints Blog

Archive

Archive for July, 2006

Two Expansion Joints for an Air Intake on a Generator Unit at a Packaged Power facility in Houston

July 11th, 2006 Comments off
Two Expansion Joints for an Air Intake on a Generator Unit at a Packaged Power facility in Houston

Expansion Joint with Angle and Plate

Two Expansion Joints for an Air Intake on a Generator Unit at a Packaged Power facility in Houston

Two Expansion Joints for an Air Intake on a Generator Unit at a Packaged Power facility in Houston

These 59” x 39.5” fabric expansion joints were fabricated using a 1/8” thick neoprene sheet. The joints were then bonded to the carbon steel angles and plates, and secured using stainless steel band clamps, with T-bolt latches. The carbon steel angles and plates were primed and finished at Piping Technology & Products’ paint production facility. The expansion joints were designed to facilitate any vibration and movement during the generator units’ normal operation.

border

Contact Us: +1 (281) 241-9418 Toll Free: (855) 591-0906 Fax: +1 (713) 731-8640 sales@usbellows.com
Our Parent Company: Piping Technology Pipe Supports, Pipe Clamps, Pipe Hardware & Insulated Pipe Shoes
Fellow Subsidiaries: Sweco Fab: ASME Vessels, Pig Launchers, Duct Work, Strainers & Spectacle Blinds
 Pipe Shields: Pre-Insulated Pipe Supports, Slides, Guides & Anchors

Fronek Anchor/Darling
: Snubbers, Sway Struts & Sway Braces


Copyright © 2017  U.S. Bellows, Inc. All Rights Reserved. Privacy Policy