Pressure Balancing Expansion Joints are Ideal for Absorbing Thermal Expansion of Equipment — The Expansion Joints Blog
Home > Pressure Balanced Expansion Joints > Pressure Balancing Expansion Joints are Ideal for Absorbing Thermal Expansion of Equipment

Pressure Balancing Expansion Joints are Ideal for Absorbing Thermal Expansion of Equipment

May 30th, 2012

The pressure thrust produced by low pressures can be tremendous in large diameter systems, just as it can be at normal pressure ratings in small pipes. To avoid expensive anchors, to keep long pipe runs in tension, to prevent buckling, or reduce reaction forces on equipment, the pressure in the pipe can be used to generate balancing forces within the expansion joint. These combinations of bellows and thrust restraining structural components can accept almost any combination of movements, as shown in the following examples.

Example of how the pressure in the pipe can be used to generate balancing forces within a pressure balanced elbow expansion joint.The pressure balanced elbow is ideal for absorbing the thermal expansion of equipment, such as turbines, pumps and compressors, which rely upon low reaction forces on their inlet and exhaust flanges. In this example, only an intermediate anchor is provided at the elbow, to isolate the equipment from any forces produced in the remaining piping.

The pressure thrust force produces tension on the equipment flange, but the only forces produced by the deflection, are the spring resistance of the bellows within the expansion joint. The spring rate of these units is the sum of the spring rates of the bellows on each side of the elbow, and care must be taken to provide a unit which produces spring forces low enough to satisfy the equipment maximums as stated by the equipment manufacturer. Bellows may also be cold sprung to reduce these forces even lower.

Example of how the flange is subjected to an axial force equal to the pressure thrust.Example of how the flange is subjected to an axial force equal to the pressure thrust. In this example, which may be typical for a turbine exhaust application, the force on the machine’s flange is the spring reaction of the bellows in lateral deflection, as described in the above example. Again, the flange is also subjected to an axial force equal to the pressure thrust, as if it were capped, but the turbine’s mounts are not. The pipe guide between the expansion joint and the equipment flange absorbs the forces produced by the thermal expansion of the pipe, along its axis.

View all the examples in the full article on, Pressure Balancing Expansion Joints.

Comments are closed.
border

Contact Us: +1 (281) 241-9418 Toll Free: (855) 591-0906 Fax: +1 (713) 731-8640 sales@usbellows.com
Our Parent Company: Piping Technology Pipe Supports, Pipe Clamps, Pipe Hardware & Insulated Pipe Shoes
Fellow Subsidiaries: Sweco Fab: ASME Vessels, Pig Launchers, Duct Work, Strainers & Spectacle Blinds
 Pipe Shields: Pre-Insulated Pipe Supports, Slides, Guides & Anchors

Fronek Anchor/Darling
: Snubbers, Sway Struts & Sway Braces


Copyright © 2017  U.S. Bellows, Inc. All Rights Reserved. Privacy Policy