new  
new
 
 
   
Loading

Contact Us:
(855) 591-0906 or Local: +1 (281) 241-9418
Facebook
left border
 
Home » Categories » Metallic Expansion Joints

How does a pressure balanced expansion joint work?

A pressure balanced expansion joint is really a combination of several types. Its purpose is to retain and balance the pressure thrust so that main anchoring of the pipe or adjacent equipment is not required, and forces and movements on attachment flanges of delicate equipment, such as turbines, are kept to acceptably low levels. The deflections to be accepted are handled by the proper type of expansion joint, which normally, and as shown in the above sketch, is a tied universal type to accept lateral movements. However, the pressure balanced elbow is usually required because axial deflections are also present. In order to accept these movements, a bellows is added beyond the elbow with the same cross-sectional area as the ones in the universal section.

This balancing bellows is connected by the tie rods to the pipe beyond the universal section; in this way the pressure thrust is contained as tension in the tie rods. The section of the expansion joint between the tie rods, which includes the elbow, is now free to move axially, with the only resistance being a function of the spring rates of the bellows. Because of their arrangement, however, the spring rate of the entire expansion joint is the sum of the spring rates of the balancing and the universal bellows. This is a constant volume system, in that when the universal end compresses, the balancing end extends the same amount. All of the lateral deflection is absorbed by the universal end, and there is no lateral deflection imposed on the balancing end. Therefore, the balancing bellows is almost always a single bellows type.

60 Inch Pressure Balanced Expansion Joint with Turning Vanes
60" Pressure Balanced Expansion Joint with Turning Vanes


Related Articles
What is a swing expansion joint?
Added on Wed, Jul 6, 2011
What is a metallic expansion joint?
Added on Thu, Feb 10, 2011
Where should we use carbon steel expansion joints?
Added on Wed, Jul 6, 2011
What is a flange on an expansion joint?
Added on Wed, Jun 29, 2011
What are unreinforced bellows?
Added on Wed, Jun 29, 2011
 
border

Contact Us: +1 (281) 241-9418 Toll Free: (855) 591-0906 Fax: +1 (713) 731-8640 sales@usbellows.com
Our Parent Company: Piping Technology Pipe Supports, Pipe Clamps, Pipe Hardware & Insulated Pipe Shoes
Fellow Subsidiaries: Sweco Fab: ASME Vessels, Pig Launchers, Duct Work, Strainers & Spectacle Blinds
 Pipe Shields: Pre-Insulated Pipe Supports, Slides, Guides & Anchors

Fronek Anchor/Darling
: Snubbers, Sway Struts & Sway Braces


Copyright © 2017  U.S. Bellows, Inc. All Rights Reserved. Privacy Policy