|Home » Categories » General Questions|
Is it okay to put guides on only one side of the expansion joint?
|It depends upon the pipeline design. For example, if there is a long run of pipe on both sides, then we need guides on both sides. If the expansion joint is located close to an anchor, then guides are only required on the long side.|
Are there special considerations for bellows material that do not have a fatigue endurance limit such as titanium?
Added on Thu, May 15, 2014
What is bellows I.D.?
Added on Tue, Feb 8, 2011
What is the bellows of an expansion joint?
Added on Mon, Feb 7, 2011
Do externally pressurized bellows need anchors for thrust load?
Added on Fri, Oct 19, 2012
What’s the thickness limitation of a single layer expansion joint?
Added on Sat, Dec 10, 2011