|Home » Categories » General Questions|
What are the guidelines on how to locate anchors and expansion joints in chilled water risers?
The anchors are located at the lower floor and upper floor of chilled water risers and
guides should be located on alternating floors. The expansion joints should
then be located near the main anchors.
How much tension is needed to prevent a pipe from buckling?
Added on Wed, Jun 29, 2011
What type of material is normally used in the accumulation barrier?
Added on Thu, May 15, 2014
Are you carrying out finite element analysis for designing the bellows?
Added on Thu, Nov 3, 2011
On a lateral tied expansion joint, is there space allowed in between the nut and the retainer to functionally avoid tilt of the tie-rod when at the operating temperature?
Added on Mon, Jun 18, 2012
What type of EJ do I use so that I don’t need to design for the pressure thrust force?
Added on Fri, May 9, 2014