|Home » Categories » General Questions|
What does cold preset 2.5" mean?
|Cold preset of 2.5" is performed in the shop on one side of the center line so that in operation the expansion joint will return to the neutral position.|
Do you include or recommend adding construction tolerances to the calculated thermal movements the expansion joints are supposed to accommodate?
Added on Thu, May 15, 2014
Do you normally recommend tie-rods for a single expansion joint?
Added on Mon, Jun 18, 2012
What are the three basic movements within a joint?
Added on Wed, Jun 29, 2011
Why should I use a double offset expansion joint?
Added on Sat, Apr 16, 2011