|Home » Categories » General Questions|
What’s the thickness limitation of a single layer expansion joint?
|The thickness limitation of an expansion joint depends on the bellows diameter and the maximum thickness that we can make is usually about .120 inches thick in the largest sizes.|
Is it okay to punch a hole into an expansion joint?
Added on Fri, May 9, 2014
What is the smallest inner diameter you can fabricate?
Added on Thu, May 15, 2014
What is the bellows of an expansion joint?
Added on Mon, Feb 7, 2011
Are you carrying out finite element analysis for designing the bellows?
Added on Thu, Nov 3, 2011