Contact Us: +1 (281) 241-9418 Toll Free: (855) 591-0906
Se habla espaņol
left border  

Bellows Expansion Joint: Pressure Loads, Anchors & Guides

Tension & Compression System
Bellows "PA" load
Bellows Effective Thrust Area
Main Anchor Design
Intermediate Anchors, Pipe Guides and Pipe Buckling
Tension Systems
(a) Bellows Thrust Load
(b) Results of Sample Problems

=Bellows Effective Thrust Area=

Bellows TID Fluid Area:
It seems reasonably apparent that in a system with a bellows the pipe internal fluid pressure load is not balanced by pipe longitudinal tensile forces and must be restrained by external forces. It can also be seen that if the bellows ID exceeds the pipe ID, an additional pressure force will be transmitted through the pipe as a compression load which must also be externally restrained. Hence one component of the total bellows thrust load is based on the bellows ID.

Bellows ID Area = 

Corrugation Sidewall Thrust:
It can also be visualized that internal pressure acting on the sidewall of the corrugation would tend to spread the corrugation out in the longitudinal direction, and this load must be restrained by an external reaction force. As an approximation consider a 1" wide radial strip cut out of a corrugation.


For a fixed ended beam with uniform load, RID = ROD  
Hence one half of the corrugation sidewall load is carried in tension at the crest of the corrugation. The other half it transmitted through the neck of the corrugation as a compressive force. This force must be resisted by the external main anchors and results in a (generally) small longitudinal compressive stress in the pipe.

Sidewall Effective Area =

But ID + h = mean dia. = Dm

Therefore, Sidewall Effective Area =

Total Effective Thrust Area:

Ae=ID area + Sidewall area

A more precise development of corrugation sidewall load and an equation for bellows effective thrust area is given in the Appendix. A comparison on 5 sample problems of typical bellows dimensions, including one extreme case of OD/ID ratio, shows that the percent error involved in using the mean diameter approximation is generally less than 1% and only 1 1/2% in the extreme example.
  Return to previous

Contact Us: +1 (281) 241-9418 Toll Free: (855) 591-0906 Fax: +1 (713) 731-8640
Our Parent Company: Piping Technology Pipe Supports, Pipe Clamps, Pipe Hardware & Insulated Pipe Shoes
Fellow Subsidiaries: Sweco Fab: ASME Vessels, Pig Launchers, Duct Work, Strainers & Spectacle Blinds
 Pipe Shields: Pre-Insulated Pipe Supports, Slides, Guides & Anchors

Fronek Anchor/Darling
: Snubbers, Sway Struts & Sway Braces

Copyright © 2017  U.S. Bellows, Inc. All Rights Reserved. Privacy Policy