Request A Quote

Single Flanged Expansion Joints for a Leading Manufacturer & Designer of Transformers & Power Supplies for an Industrial Applications Company

August 24, 2020

U.s. bellows custom designed single fanged expansion joints for a leading manufacturer & designer of transformers & power supplies for an industrial applications company

Type: Single Flanged Expansion Joint
Size: 5″ Length | 6″ ID | 11″ O.D.
Material: ASTM A240-316 Stainless Steel
Design 200°F | 150 psig | 7,942 lb/in. Lateral Spring Rate
0.625 ” Axial Travel | 803 lb/in. Axial Spring Rate
0.125″ Lateral Offset | 225 psig Test Pressure
Testing: 100% Dye-Penetrant | Air, Soap, & Bubble

The single expansion joint type is simply a bellows element with end connections. It is the least expensive type but requires that the piping be controlled as to the direction of the movements required of the unit. This type of expansion joint should not be expected to control the movement of the pipe. If the piping analysis shows that the expansion joint must accept axial compression, then the piping must be guided and constrained in other locations so that only that axial movement will occur. The flanges and bellows are fabricated from ASTM A240-316 stainless steel. The units are 6″ in diameter, 5″ long, and have an 11″ outside diameter. Design conditions are: design pressure = 150 psig, test pressure = 225 psig, design temp. = 200°F, axial travel = 0.625″ compression, axial spring rate = 803 lb/in., lateral offset = 0.125″, and lateral spring rate = 7,942 lb/in. *Designed in accordance with the Standards of the Expansion Joint Manufacturers Association, 10th E, and welding per ASME Boiler and Pressure Vessel Code Section IX.

Read More

Tied Universal Elbow Expansion Joint Custom-Designed for Ammonia and Waste Processing for a Liquid Nitrogen Fertilizer Plant

August 10, 2020

Usbellows tied universal expansion joint 143516

Type: Tied Universal Elbow Expansion Joint
Size: 20″ Dia. | 112″ Face-of-Flange to Center Line of Elbow OAL
Material: Inconel® 625 Bellows | 304 H Stainless Steel
Design Operating Temp: 1,150°F at 140 psig | 4″ Lateral Deflection
Testing: Dye Penetrant Examined | 100% X-Rayed Bellows | Hydro-tested

U.S. Bellows, Inc. custom-designed a tied universal elbow expansion joint for ammonia and waste processing for a nitrogen fertilizer plant. The bellows and liner are fabricated from Inconel® 625. The pipe, tie rods, and flanges are fabricated from 304 H stainless steel. It is designed for an operating temperature of 1,150°F at 140 psig and 4″ of lateral deflection. The assembly is 20″ in diameter and 112″ face-of-flange to the centerline of elbow OAL. The unit was 100% x-rayed, dye-penetrate examined, and hydro-tested before shipment.

Read More
Top